Adapting Adaptation Value

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

To be done after draining reducing agent or replacing components.

The adaptation value in the engine control module must be adapted using the Vehicle Diagnostic Tester when the reducing agent is drained or one of the components listed below is replaced.

Active tank
Reducing agent pump
Reducing agent injector
Reducing agent line
Engine control module

-- Perform an adaptation using the Vehicle Diagnostic Tester in the "Guided Functions" mode.