NOx Sensor -G295-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

Fig 1: Identifying NOx Sensor -G295-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrows- and remove the NOx Sensor Control Module -J583-.

-- Remove the NOx Sensor -G295- -4-.

Fig 2: Identifying Installation Location Inside Exhaust System Tract

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -1, 2, 3 and 5-.