Intake Manifold Upper Section, Removing And Installing: Installing

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications. Refer to OVERVIEW - INTAKE MANIFOLD

NOTE:

Always replace gaskets and seals.

Hose connections and charge air system hoses must be free of oil and grease before installing.

Make sure the intake ducting is not blocked by leaves or dirt; clean if necessary.

Secure all hose connections using hose clamps appropriate for the model type. .