LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (3.0L - Turbocharger & Supercharger - Engine Code: CATA) >> 21 Turbocharger, Supercharger >> Charge Air Cooler (Vehicles Through 05/2010) >> Charge Air Cooler Bypass Control Unit -J865-, REMOVING AND INSTALLING >> Removal

Charge Air Cooler Bypass Control Unit -J865-, REMOVING AND INSTALLING: Removal

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Front/Rear Noise Insulation
GWWA10-10441Courtesy of AUDI OF AMERICA, LLC

-- On a vehicle with air suspension, activate vehicle lift mode. Refer to VEHICLE LIFT MODE .

-- Remove the front noise insulation -1-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

Fig 2: Lower Air Duct Pipe, Removal & Installation
GWWA21-10381Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

-- Lift the clips -1-, loosen the clamp -3- and -4- and remove the air duct hoses.

-- Loosen the clamp -2- and remove the air duct tube.

Fig 3: Hose Clamp -2-, Bolts -Arrows-
GWWA21-10444Courtesy of AUDI OF AMERICA, LLC

-- Remove the screws -arrows- and remove the Charge Air Cooler Control Unit -J865- -1-.