Transmission Park Selector Switch - F305-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Part Of Shift Gate -1-

Courtesy of AUDI OF AMERICA, LLC

-- Remove selector mechanism function unit. Refer to SHIFT MECHANISM FUNCTION UNIT, REMOVING AND INSTALLING .

-- Remove the shift gate. Refer to SHIFT GATE, REMOVING AND INSTALLING .

-- Pry out the retaining pin -A- in direction of -arrow- with a screwdriver.

-- Remove the first micro-switch -B-.

-- Disengage electrical wiring from tab -arrow C- and remove micro-switch from shift mechanism.

-- Disconnect the connector -D- from the Shift Lock Solenoid -N110-.

Fig 2: Identifying Microswitch Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -E- upward.

-- Push the tab -C- in direction of -arrow 1-.

-- Remove the second micro-switch -B- in direction of -arrow 2-.

-- Disengage electrical line at selector mechanism -arrow A-.