Selector Lever Position P Locking Lever, Removing And Installing: Installing
WARNING: This page is about a different car, the 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Insert the locking lever and secure it with both left and right bearing bushings -2-.
-- Make sure the locking lever is working correctly.
- The emergency release lever -arrow- must move easily and can be moved up and down.
NOTE:
If will be difficult to move emergency release lever -arrow- if the bushings are installed incorrectly.
If the emergency release lever is difficult to move, ignition key removal lock will not work.
-- Install the shift gate. Refer to SHIFT GATE, REMOVING AND INSTALLING .