Selector Mechanism Function Unit Lower Section, Removing And Installing: Installing

WARNING: This page is about a different car, the 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications. Refer to SELECTOR MECHANISM .

-- Install the selector mechanism function unit lower section into the opening from the top.

Make sure the seal fits correctly on the selector mechanism function unit lower section.

-- Guide the selector lever cable and rubber grommet -3- through the hole inside the selector mechanism function unit lower section.

-- Tighten the bolts -arrows-.

Fig 1: Identifying Hooks -1 To 2- And Bolts -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Install the hooks -1 and 2-.

-- Install the rubber grommet -arrow- on the around the selector lever cable in the selector mechanism function unit lower section.

Fig 2: Pushing Boot Forward And Out From Shift Unit

Courtesy of AUDI OF AMERICA, LLC

-- Install shift mechanism function unit. Refer to SHIFT MECHANISM FUNCTION UNIT, REMOVING AND INSTALLING .