Selector Lever Handle, Removing And Installing: Installing

WARNING: This page is about a different car, the 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Securing Interlock Button In Pulled-Out Position Using A Cable

Courtesy of AUDI OF AMERICA, LLC

NOTE:

In order to install the selector lever handle, the locking button must be pulled out all the way and secured either with a cable tie -arrow- or with the assembly tool supplied with a new handle.

If the lock button was not secured, do not pull it out from the handle using mechanical aids. Position the compressed air gun under the handle and press the locking button out with compressed air.

-- Install the shifter lever handle completely on the shifter lever. The lock button faces toward the driver.

The handle must lock into the selector lever ring groove.

-- Remove cable tie or assembly aid, lock button mechanism engages in vertical groove on selector lever.

-- If necessary, press lock button back into selector lever handle.

-- Clamp the handle -2- to the selector lever, using a new clamp -arrow-. Use Hose Clip PliersVAG1275A.

Fig 2: Identifying Selector Lever Boot, Selector Lever Handle And Clamp

Courtesy of AUDI OF AMERICA, LLC

-- Install the selector lever boot frame -1- in the center console.