Selector Lever Boot, Removing From Selector Lever Handle: Installing

WARNING: This page is about a different car, the 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Selector lever boot installed position.

The longer side of the selector lever boot frame faces toward the driver side (toward the Selector Lever Transmission Range Position Display Unit -Y26-).

-- Install the handle on the selector lever. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .