Right Coolant Pipe: Removing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.

-- Drain the coolant. Refer to COOLING SYSTEM, DRAINING AND FILLING .

-- Remove rear right coolant pipe. Refer to REAR RIGHT COOLANT PIPE .

-- Remove electrical connectors -1 to 4- from bracket on right strut tower.

Fig 1: Identifying Electrical Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Remove connector bracket from strut tower.

-- Disconnect electrical harness connector -arrow- at Camshaft Position (CMP) sensor 3 -G300-.

Fig 2: Identifying Electrical Harness Connector At Camshaft Position (CMP) Sensor 4 G301

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -2 and 3-.

Fig 3: Identifying Bolts And Coolant Pipe For Coolant Hoses

Courtesy of AUDI OF AMERICA, LLC

-- Remove right coolant pipe from coolant hoses at places marked with -1, 4, 5, 6-.