Fuel Cooler Pump -V166-, THROUGH 05/2010, REMOVING AND INSTALLING

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Hose Clamps - Up To 25mm3094
Hose Clip PliersVAS6362

Removal

Fig 1: Identifying Front/Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- On a vehicle with air suspension, activate vehicle lift mode. Refer to VEHICLE LIFT MODE .

-- Remove the front noise insulation -1-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

Fig 2: Identifying Connector -1-, Bolt -2-, Hose Clamps -3 & 4-, And Fuel Cooler Pump

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -3- and -4- and remove the coolant hoses and clamps Hose Clamps - Up To 25mm3094.

-- Remove the bolt -2- and the Fuel Cooler Pump -V166-.

Installation

Install in reverse order of removal. Note the following:

NOTE:

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

-- Tighten the Fuel Cooler Pump -V166- to the longitudinal member, refer to Figure.

-- Check the coolant level, refer to COOLANT, DRAINING AND FILLING .

-- Install the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- On a vehicle with air suspension, deactivate vehicle lift mode. Refer to VEHICLE LIFT MODE .