Overview - Drive Plate
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Drive Plate
- Check the holes in the torque converter for cracks and wear grooves.
- Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Bolt
- 60 Nm +90°
- Replace
- Sensor Wheel
- For Engine Speed Sensor -G28-
- Check sensor wheel. Refer to SENSOR WHEEL, CHECKING .CAUTION:
There is a risk of destroying the sensor wheel by magnetic force.
- Do not place the sensor wheel near magnets (for example inspection lamp base, or speakers).
- If the drive plate/flywheel or the sensor wheel disjoints itself or was replaced, the sensor wheel function must be checked before installing. Refer to SENSOR WHEEL, CHECKING .
- Shaft Seal
- For the crankshaft on the transmission side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
- Alignment Pin
- Crankshaft