Crankshaft, Measuring Axial Play

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Dial Gauge HolderVW387
Dial Gauge - 0-10mmVAS6079

Procedure

Fig 1: Attaching Dial Indicator VAS 6079 Together With Dial Gauge Holder VW 387 To Cylinder Block

Courtesy of AUDI OF AMERICA, LLC

-- Install the Dial Gauge - 0-10mmVAS6079 with the Dial Gauge HolderVW387 on the cylinder block as shown in the illustration.

-- Place the dial gauge against the crankshaft counterweight.

-- Press the crankshaft against the dial gauge by hand and set the gauge to "0".

-- Press the crankshaft off the dial gauge and read the measurement.

Axial play:

New: 0.90 to 0.251 mm.

NOTE:

Wear limit not yet determined.