| Air Filter Lower Section to Wheel Housing |
- |
10 |
| Catalyst Temperature Sensor 12 |
- |
45 |
| Clamp to Air Guide Hose |
- |
5.5 |
| Differential Pressure Sensor, Nut |
- |
3.5 |
| Differential Pressure Sensor Pressure Line to Particulate Filter |
- |
45 |
| Distribution Piece Banjo Bolt to Fuel Rail |
- |
25 |
| Engine Cover Bolt |
- |
5 |
| Exhaust Gas Temperature Sensor2 |
- |
45 |
| Fuel Pressure Sensor to Cylinder Bank 2 |
- |
30 |
| Fuel Rail for Cylinder Bank 1 |
- |
22 |
| Fuel Rail for Cylinder Bank 2 |
- |
22 |
| Fuel Return Line Banjo Fitting |
- |
25 |
| Heated Oxygen Sensor with Oxygen Sensor Heater2 |
- |
50 |
| High Pressure Fuel Lines to Cylinder Bank 2 |
- |
25 |
| High Pressure Line Union Nut |
- |
25 |
| High Pressure Pump Bracket to High Pressure Pump |
| |
M6 |
9 |
| |
M8 |
23 |
| High Pressure Pump Toothed Belt Sprocket, Nut |
- |
70 |
| Idler Roller |
- |
23 |
| Injector Unit Cover to Cylinder Head Cover |
- |
5.5 |
| Intake Flap Motor to Lower Intake Manifold |
- |
10 |
| Lower Intake Manifold1 |
- |
9 |
| Mass Airflow Sensor to Air Filter Upper Section |
- |
1.5 |
| NOx Sensor, Nut |
- |
2.5 |
| NOx Sensor 2, Nut |
- |
3.5 |
| Plug to Upper Intake Manifold |
- |
10 |
| Pressure Lines on Particulate Filter |
- |
45 |
| Protective Plate to High Pressure Pump Bracket |
- |
9 |
| Rear Toothed Belt Guard to Block |
- |
9 |
| Tensioning Bracket for Fuel Injector |
| -Bolt |
- |
5 |
| -Nut |
- |
10 |
| Throttle Valve Control Module to Upper Intake Manifold |
- |
9 |
| Toothed Belt Tensioning Roller |
- |
23 |
| Toothed Belt Drive Sprocket |
- |
75 |
| Upper Intake Manifold |
- |
9 |
| Upper Intake Manifold Drain Plug |
- |
10 |