ADBLUE® Transfer Pump

Special tools and workshop equipment required

Removing

Follow all safety precautions SAFETY PRECAUTIONS .

Follow the guidelines for cleanliness. Refer to CLEAN WORKING CONDITIONS .

WARNING:

Danger due to reducing agent leaking out.

To prevent large amounts of reducing agent when opening the metering line, wait for the recirculation process to complete. Refer to SAFETY PRECAUTIONS .

-- Remove the reducing agent passive tank. Refer to ADBLUE® PASSIVE TANK .

NOTE:

Place a clean cloth under the separating location to catch any reducing agent that may leak out.

Seal off all open lines and connections with clean plugs.

WARNING:

The reducing agent can cause skin irritation.

Avoid contact with skin and eyes! Always wear protective gloves and safety glasses.
If reducing agent should get on your skin, wash it off immediately with soap and water.
If reducing agent gets in your eye, rinse the eye for several minutes with water.
Never inhale or swallow the reducing agent!
Should you swallow any reducing agent, rinse your mouth, drink plenty of water and contact a doctor immediately.

-- Remove the transfer line -1- by pressing the release button.

Fig 1: Reducing Agent Transfer Pump And Rubber Bracket -2-

Courtesy of AUDI OF AMERICA, LLC

-- Clamp off the hose -5- with the 3094.

-- Carefully remove the hose from the connection on the reducing agent transfer pump -V436-.

-- Disconnect the connector -3-.

-- Remove the bolt -4- and remove the reducing agent transfer pump and rubber bracket -2-.

Installing

Install in reverse order of removal. Note the following:

For the correct tightening specifications, refer to ADBLUE® ACTIVE TANK AND ATTACHMENTS OVERVIEW .

-- Adapting adaptation value after draining AdBlue® or replacing components. Refer to ADAPTING ADAPTATION VALUE AFTER DRAINING ADBLUE® OR REPLACING COMPONENTS .