Circuit Board
Removing
Fig 1: Identifying Electrical Connectors -1 Through 7, Electrical Harness Connector -8, Circuit Board -9 And Spacer Bushings -10-
-- Remove the cooler. Refer to COOLER J698 .
-- Disconnect the electrical connectors -1 through 7-.
-- Disconnect electrical harness connector -8-.
-- Remove the bolts -arrows-.
-- Remove the circuit board -9-.
Installing
Installation is reverse of removal, noting the following:
-- Make sure the spacer bushings -10- are mounting the base plate.
-- Install the cooler. Refer to COOLER J698 .
Tightening specifications, refer to COOLER OVERVIEW .