Fender And Side Panel Trim Overview

Fig 1: Identifying Fender And Side Panel Trim Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

1. Bumper Trim
   • Make sure the fender cover gap is parallel -a-.
2. Fender Trim
3. Side Panel Trim

   Align with the edge of the side panel when installing.

4. Rear Bumper Trim
5. Rear Door Trim
   • Align with the edge of the door when installing.
6. Side Panel
7. Double Sided Adhesive Tape
   • Peel off the protective film in stages.
8. Front Wheel Housing Liner

Installing the Trim

Fig 2: Identifying Fender And Side Panel Trim Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

1. Trim
2. Roller
3. Protective Film
   • Clean the adhesive surfaces.
   • Peel off the protective film under the molding as illustrated.
   • Position the molding exactly and carefully peel off the protective strip.
   • Press the molding on in stages.
   • Using a roller, press the molding onto the bumper over the entire length.