Selector Shaft Seal
Special tools and workshop equipment required
- Pry Lever - Rmv Outside Mirror 80 - 200
- Thrust Piece T10135
Removing
-- Remove the ball socket -1- on the selector lever cable from the selector shaft lever using the 80 - 200.
Do not bend or kink the selector lever cable.
-- Remove the spring pin -1- on the selector shaft lever -2- -arrow- until it is possible to remove the lever from the shaft.
The selector shaft running surface could get damaged.
- Position the screwdriver.
-- Pierce shaft seal with a small screwdriver and pull out.
Installing
Install in reverse order, paying attention to the following:
-- Apply ATF to the circumference and the space between the sealing lips of the new shaft seal.
- Installed position: Open side of shaft seal faces transmission.
-- Slide the shaft seal onto the selector shaft.
-- Press the new shaft seal on as far as the stop using the T10135 and assembly lever -A-. Make sure the shaft seal does not tilt when doing this.
-- Install the spring pin on the selector shaft lever while it is still removed.
-- Slide the lever onto the selector shaft and install the spring pin.
-- Check the ATF level. Refer to ATF LEVEL, CHECKING .