Right Flange Shaft Seal
Special tools and workshop equipment required
- Oil Collecting and Extracting Device V.A.G 1782
- Extractor Lever VW 681
- Thrust Piece T40189
Procedure
NOTE:
Clean working conditions for the automatic transmission, refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
General repair instructions, refer to REPAIR INFORMATION .
-- Place the V.A.G 1782 under the transmission.
-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT .
-- Remove the right flange shaft seal.
-- Coat the outer circumference of the new shaft seal with axle oil.
- Installed position: The open side of the shaft seal faces the transmission.
-- Drive on in new shaft seal as far as stop. When doing this, do not bend the shaft seal or install it on an angle.
-- Install the right flange shaft. Refer to RIGHT FLANGE SHAFT .
-- Axle oil, adding to transmission after repair. Refer to FRONT FINAL DRIVE GEAR OIL, FILLING AFTER REPAIR .