Center Differential Ball Bearing

Special tools and workshop equipment required 

• Thrust Plate VW 401
• Thrust Plate VW 402
• Punch VW 412
• Thrust Disc VW 432
• Carrier Bearing Inst. Tool 3350
• Separating Device 22 to 115 mm Kukko 17/2

Removing 

Fig 1: Identifying Center Differential

Courtesy of AUDI OF AMERICA, LLC

-- Remove the center differential housing. Refer to CENTER DIFFERENTIAL HOUSING, TRANSMISSION INSTALLED .

-- Remove the center differential -1- from the input shaft.

Fig 2: Removing the ball bearing from the center differential

Courtesy of AUDI OF AMERICA, LLC

A -

Separating device 22 to 115 mm Kukko 17/2

The VW 432 faces the ball bearing.

Installing 

Fig 3: Installing the ball bearing onto the center differential

Courtesy of AUDI OF AMERICA, LLC