Side Airbag Additional Safety Precautions

CAUTION:

We recommend using original equipment seat covers.
Seat covers or extra covers that are not approved specially for use on Audi seats with side airbags must not be used.
Do not cut the backrest material in side airbag area.
When installing, seam in side airbag region must run straight.
All cushion clips have to be replaced (metal and plastic clips).
We recommend using original upholstery clips.
During installation, all upholstery clips must be placed in the same place as when removed.
If cover is damaged (with rips, burned holes, etc.) in side airbag region, it must be replaced for safety reasons so that airbag deploys correctly.
Do not repair the backrest cover in the side airbag area (because of special materials and strictly defined seams).
Always replace the backrest upholstery if the side airbag deploys.
After an accident, all damaged parts must be replaced. If no airbag unit damage is detected, the unit can still be used.
If thorax airbag units are replaced, the new thorax airbag number sticker should be removed and placed over the old sticker on the seat pan.
Do not poke the cover with an upholstery needle or other sharp objects near the airbag, the Front Passenger Seat Occupant Sensor -G128- or the passenger occupant detection system mat.