LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q5 3.2 >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> Heating, Ventilation & Air Conditioning (1 Of 2) (As Of 06.2014) >> 87 Air Conditioning >> Refrigerant Circuit >> Condenser, Removing And Installing >> CONDENSER, REMOVING AND INSTALLING, Vehicles with 2.0L, 3.0L and 3.2L >> Installing

CONDENSER, REMOVING AND INSTALLING, Vehicles with 2.0L, 3.0L and 3.2L: Installing

Installation is done is reverse order, observe the following:

NOTE:

The removed condenser contains refrigerant oil that must be returned to the refrigerant circuit (with the new condenser). Refer to REFRIGERANT CIRCUIT COMPONENTS, REPLACING (Refrigerant R134a, Servicing; Refrigerant Circuit Components, Replacing).

There are different versions of the condenser. Ensure the correct version and allocation before installing. Refer to CONDENSER, CHECKING VERSION  .

The refrigerant circuit capacity depends on which version of the condenser is installed. Refer to REFRIGERANT R134A CAPACITIES, REFRIGERANT OIL AND APPROVED REFRIGERANT OILS (Refrigerant R134a, Servicing; Refrigerant R134a Capacities, Refrigerant Oil and Approved Refrigerant Oil).

-- Install the refrigerant lines on the condenser. Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING AT CONDENSER .

Vehicles with a power steering oil cooler:

-- Install the power steering oil cooler cooling coil. Refer to HYDRAULIC FLUID COOLER, REMOVING AND INSTALLING .

All:

-- Install the cover on the lock carrier. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .

-- Evacuate the refrigerant circuit and fill it. Refer to USING SERVICE STATION . For additional information, refer to OVERVIEW - REFRIGERANT CIRCUIT, NOT OPENING THE REFRIGERANT CIRCUIT, VEHICLES WITHOUT HIGH VOLTAGE SYSTEM  and OVERVIEW - REFRIGERANT CIRCUIT, OPENING THE REFRIGERANT CIRCUIT, VEHICLES WITHOUT HIGH VOLTAGE SYSTEM  (Refrigerant R134a, Servicing; Refrigerant Circuit, Using Service Station).

-- Install the remaining removed components.

-- Turn on the ignition.

-- Check the DTC memory for the Climatronic Control Module -- display and control head and erase any displayed malfunctions, if necessary using the Vehicle Diagnostic Tester in the "Guided Fault Finding  " function.

-- Operate the A/C system after filling the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

NOTE:

Observe the information regarding operating the A/C system after filling. Refer to A/C SYSTEM, OPERATING AFTER CHARGING , (Refrigerant R134a, Servicing; A/C System, General Information). After charging the A/C system before activating the A/C system.