A/C Pressure/Temperature Sensor -G395-, REMOVING AND INSTALLING: Installing
Installation is done is reverse order, observe the following:
-- Replace the O-ring -B-. Refer to REFRIGERANT CIRCUIT SEALS . Allocate correct components .
-- Tighten the A/C Pressure/Temperature Sensor -G395- -A-.
- Tightening specification: 5 Nm.
-- Check the DTC memory for the Climatronic Control Module -J255- display and control head and erase any displayed malfunctions, if necessary using the Vehicle Diagnostic Tester in the "Guided Fault Finding " function.