Right Center Vent Motor -V111-, REMOVING AND INSTALLING: Removing
-- Move the passenger seats as far back as possible.
-- Turn off the ignition.
-- Remove the glove compartment. Refer to Storage Compartments and Covers .
-- Remove bolts -A-.
-- Remove the air guide channel -B- leading to the right instrument panel vent (passenger side).
-- Remove the air intake housing. Refer to HEATER AND A/C UNIT AIR INTAKE HOUSING, REMOVING AND INSTALLING .
-- Mark the connector -A- if necessary (to rule out an interchange in the event several connectors are disconnected at the same time).
-- Disconnect the connector -A-.
-- Remove the bolts -B-.
-- Remove the shaft -D- of the actuator -C- from the curved washer -E-.