Rear Lid Seal, Removing And Installing, AVANT: Notes

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For vehicles through MY 2011, the butt joint on the body flange must be sealed as well when replacing the rear lid seal. Refer to "Additionally Sealing the Body Flange", see Figure.

Fig 1: Rear Lid Seal (Avant)

Courtesy of AUDI OF AMERICA, LLC

Rear Lid
Rear Lid Seal
- Removing:
  -- The rear lid end piece trim panel is removed. Refer to COMPONENT LOCATION OVERVIEW - REAR LID TRIM PANELS .
  
  -- Secure the rear lid from falling down and disconnect the gas-filled strut on the body side from the left and right ball studs.
  
  -- Remove the seal from the flange on the body all the way around.
  
  -- When installing, align the seal to the upper marking -arrow- and then press it onto the flange all the way around.