Tire Pressure Monitoring Control Module 2 -J502-, Removing And Installing: Removing

The Tire Pressure Monitoring Control Module -J502- is located in the right front footwell under the instrument panel.

Before removing the Tire Pressure Monitoring Control Module -J502-, perform Guided Fault Finding under "replace control module".

-- Remove the glove compartment. Refer to STORAGE COMPARTMENTS AND COVERS .

-- Remove the sill panel. Refer to SILL PANEL STRIP, REMOVING AND INSTALLING .

-- Remove the locking mechanisms -A arrows- and the cover -arrow B-.

Fig 1: Identifying Cover And Locking Mechanisms

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and the vent -2-.

Fig 2: Identifying Bolt And Vent, Removal

Courtesy of AUDI OF AMERICA, LLC

-- Remove the cover -arrow- and the pollen filter.

Fig 3: Identifying Cover And Pollen Filter, Removal

Courtesy of AUDI OF AMERICA, LLC

-- Carefully lay the carpet aside with the help of a second technician.

-- Move the insulating mat -arrow- up.

Fig 4: Moving Insulating Mat

Courtesy of AUDI OF AMERICA, LLC

-- Release and remove the connector -3-.

Fig 5: Release And Remove Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -1- and remove the Tire Pressure Monitoring Control Module -J502- -1- upward.