Setting Device Basic Set : Vas6430/1 Converting, For The Calibration Procedure

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Setting Device Basic Set:VAS6430/1

Before performing the calibration procedure, check location of the versicle slots on the :VAS6430/1 . The :VAS6190A may need to be adapted before performing the calibration.

The :VAS6430/1 must be adapted before the adjustment procedure. If this is done during the adjustment procedure, the pre-calibration on the :VAS6430/1 must be repeated.

-- For the adjustment procedure, the vertical slits in mounts -1 through 4- must be inserted so that laser beam is approximately centered vertically when it contacts the sensor lens.

Fig 1: Identifying VAS 6190 And Vertical Slits In Mounts -1- Through -4-

Courtesy of AUDI OF AMERICA, LLC

-- The original nut at the top of the horizontal slits must be replaced with a standard nut -3-.

Fig 2: Identifying Mirror -1-, Vertical Slits -2- And Bolt -3-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The original nut at the top of the horizontal slits must be replaced with a standard nut so that the mirror can be slide far enough to the center.

-- The mirror at the center -1- must be removed and re-installed all the way to the left in direction of -arrow- near the vertical slits -2-.

Fig 3: Identifying Mirror -1-, Mirror Adjustment Knob And Vertical Slits -2-

Courtesy of AUDI OF AMERICA, LLC

-- Then the mirror -1- must be slide on horizontal slits as far as stop on vertical slits -2-.

Fig 4: Identifying Mirror -1-, Vertical Slits -2- And Bolt -3-

Courtesy of AUDI OF AMERICA, LLC