Acc, Calibrating, Calibration Procedure With Setting Device Basic Set :Vas6430/1: Notes

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Setting Device Basic Set:VAS6430/1
ACC Adjuster:VAS6190/2
Vehicle Diagnostic Tester
Wheel Alignment Computer

NOTE:

Before driving the vehicle onto the alignment stand, check if there is enough space between the vehicle and the :VAS6430/1 . The distance between the :VAS6430/1 and the vehicle must be 120 cm ± 5 cm.

If there is not enough space, drive vehicle the backward on the alignment stand in order to be able to use the space.

Before performing the calibration procedure, check the position of the calibration mirror and adjust it if necessary.

The :VAS6430/1 must be adapted before the adjustment procedure. If this is done during the adjustment procedure, the pre-calibration on the :VAS6430/1 must be repeated.

Before beginning the adjustment, check the DTC memory and correct any malfunctions present.

The adjustment procedure is described here using the :VAS6430/1 .

NOTE:

Do not perform the steps under "Calibration procedure without a previous axle alignment" if an axle alignment has already been performed.