Overview - Retainer

NOTE:

In the illustration is 2/3 left rear seat is shown.

Fig 1: Identifying Backrest Release

Courtesy of AUDI OF AMERICA, LLC

Connector Station
- For the upper and lower cable
- Clipped to the seat frame
Rear Seat
Bracket
- For the upper cable
- Quantity: 4
Upper Cable
- For the backrest release
- Removing and installing. Refer to UPPER CABLE, REMOVING AND INSTALLING .
Bolt
- 1.5 Nm
Actuator
- For the backrest release
- Removing and installing. Refer to BACKREST LOCK ADJUSTMENT ACTUATOR, REMOVING AND INSTALLING .
Bracket
- For the actuator
- Removing and installing. Refer to ACTUATOR BRACKET, REMOVING AND INSTALLING .
Nut
- 3 Nm
- Quantity: 2
Release Handle
- Removing and installing. Refer to LOCKING LEVER, REMOVING AND INSTALLING .
Washer
Bolt
- 18 Nm
- Install with locking compound. .
Lower Cable
- For the backrest release
- Removing and installing. Refer to LOWER CABLE, REMOVING AND INSTALLING .
Backrest Release Handle
- Removing and installing. Refer to LOCKING HANDEL, REMOVING AND INSTALLING .