Passenger Occupant Detection System, Removing And Installing: Installing
Do not disconnect the electrical connectors on the Passenger Occupant Detection System Pressure Sensor -G452- and the Seat Occupied Recognition Control Module -J706-.
Install in reverse order of removal. Note The Following :
- Follow all safety precautions when working with pyrotechnic components (refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS ) and on the passenger occupant detection system (refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC ).
- Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
- Do not bend the seat occupied recognition pressure hose and mat.
Make sure the connectors are installed correctly and are secure.
Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
When working on vehicles with the ignition already switched on or that are ready to drive there is a danger of the engine starting unexpectedly and of being poisoned by gas in enclosed areas. Risk of body parts and/or clothing being clamped or pulled.
Perform the following before switching on the ignition:
- Move the selector lever into P.
- Activate the parking brake
- Turn off the ignition.
- Open the hood
- Connect Battery Charger VAS5095A to the battery jump start terminal.
- Turn on the ignition.
-- Connect the battery ground cable with the ignition turned on. Refer to GROUND CABLE WITH BATTERY MONITORING CONTROL MODULE -J367-, REMOVING AND INSTALLING / BATTERY, DISCONNECTING AND CONNECTING .
When installing a new service kit and after each repair to the front passenger seat during which the seat and/or the backrest cover is >>disengaged<<, a basic setting procedure must be performed for the passenger occupant detection system control module. Refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC .
-- At the end, select the "Airbag" function in "guided fault finding" using Vehicle Diagnostic Tester.
- Seat Occupied Recognition Control Module -J706- basic setting