LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q5 3.2 >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Seat Upholstery & Covers >> 74 Seat Upholstery, Covers >> Rear Seat Covers And Cushions >> Backrest Heating Element, Removing And Installing >> Installing

Backrest Heating Element, Removing And Installing: Installing

-- Align new heating element on backrest cushion.

CAUTION:
  • Make sure the new heating element is affixed to the old heating element.
  • Remove the protective foil off the heating element in the affixing sequence.
  • When removing the protective film, make sure the heating element is not damaged and that it is attached without wrinkles.

-- Bond the individual areas of the heating element in the sequence -A and B-.

-- Route the connecting wires to the individual heating surfaces in the base of the gaps -arrows-.

-- Pull electrical wire -3- through the slit in cushion -2-.

Install in reverse order of removal.

scientia non olet · About LEMON Manuals