Setting Device Basic Set Vas6430/1 Converting For Adjustment Procedure

Special Tools And Workshop Equipment Required 

• Setting Device Basic Set VAS6430/1

Before performing the adjustment, check in which mount the vertical slits on the Setting Device Basic Set VAS6430/1 are located. The Setting Device Basic Set VAS6430/1 may have to be adapted before performing adjustment.

The Setting Device Basic Set VAS6430/1 must be adapted before the adjustment procedure. If this is done during the adjustment procedure, the pre-calibration on the Setting Device Basic Set VAS6430/1 must be repeated.

-- For the adjustment procedure, the vertical slits in mounts -1- through -4- must be inserted so that laser beam is approximately centered vertically when it contacts the sensor lens.

Fig 1: Identifying VAS 6190 And Vertical Slits In Mounts -1- Through -4-

Courtesy of AUDI OF AMERICA, LLC

-- The original nut at the top of the horizontal slits must be replaced with a standard nut -3-.

Fig 2: Identifying Mirror -1-, Vertical Slits -2- And Bolt -3-

Courtesy of AUDI OF AMERICA, LLC

-- The mirror at the center -1- must be removed and installed again all the way to the left -arrow- near the vertical slits -2-.

Fig 3: Identifying Mirror -1-, Mirror Adjustment Knob And Vertical Slits -2-

Courtesy of AUDI OF AMERICA, LLC

-- Then the mirror -1- must be slide on horizontal slits as far as stop on vertical slits -2-.

Fig 4: Identifying Mirror -1-, Vertical Slits -2- And Bolt -3-

Courtesy of AUDI OF AMERICA, LLC