LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q5 2.0T >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation & Air Conditioning (1 Of 2) (As Of 06.2014) >> 87 Air Conditioning >> A/C Compressor >> Belt Pulley, Removing And Installing >> BELT PULLEY, REMOVING AND INSTALLING, A/C COMPRESSOR WITH A/C Clutch -N25- >> Clutch Plate, Removing and Installing

Clutch Plate, Removing and Installing

-- Turn off the ignition.

-- Perform the preliminary work as for replacing the belt pulley. Refer to PRELIMINARY WORK FOR REPLACING BELT PULLEY .

-- Remove the cap -A-.

Fig 1: Identifying A/C Compressor Input Shaft Components
GWWA87-11102Courtesy of AUDI OF AMERICA, LLC

-- Hold the A/C compressor input shaft -B- secure with a commercially available socket (7 mm) and turn the clutch plate -C- in direction of -arrow-.

NOTE:

The torque to drive the A/C compressor is transferred to the clutch plate -C- via the threaded connection. If, while the A/C compressor is working, the clutch plate -C- was attached to the A/C compressor shaft so tight, that it cannot be loosened (the 7 mm Allen wrench -B- cannot transmit the necessary torque) then the A/C compressor must be replaced.

scientia non olet · About LEMON Manuals