Refrigerant Lines For Battery Cooling Module In Luggage Compartment, Removing And Installing: Installing

Installation is carried out in the reverse order while observing the following.

NOTE:

Follow the instructions for installing the O-rings. Refer to REFRIGERANT CIRCUIT SEALS .

Following attachment, check routing of refrigerant lines. They must be inserted in holders provided and not make contact with other components.

-- Replace the O-ring seals -4-. Allocate correct version.

Fig 1: Identifying Refrigerant Line Connection Components

Courtesy of AUDI OF AMERICA, LLC

-- Clean the refrigerant line connections -3 and 5- and inspect them for damage.

-- Make sure the O-rings -4- sit correctly inside the grooves of the respective mount.

-- Check the alignment pin -2- (not present on all connections) for damage and make sure that it is seated correctly.

-- Tighten the bolts -1-.

-- Install the remaining removed components.

-- Evacuate the refrigerant circuit and fill it. Refer to USING SERVICE STATION . For additional information, refer to OVERVIEW - REFRIGERANT CIRCUIT, NOT OPENING THE REFRIGERANT CIRCUIT, VEHICLES WITHOUT HIGH VOLTAGE SYSTEM and OVERVIEW - REFRIGERANT CIRCUIT, OPENING THE REFRIGERANT CIRCUIT, VEHICLES WITHOUT HIGH VOLTAGE SYSTEM (Refrigerant R134a, Servicing; Refrigerant Circuit, Using Service Station).

-- Electrical connections and routing. Refer to the appropriate SYSTEM WIRING DIAGRAM.

-- Energize the power supply to the high voltage system. Refer to HIGH VOLTAGE SYSTEM, RE-ENERGIZING .

Restart the high voltage system

CAUTION:

Risk of electrocution

Death or serious bodily injury by electric shock

The high voltage system may only be restarted by qualified personal (Audi high voltage technicians).
Make sure the vehicle is energized using the "Guided Fault Finding" on the Vehicle Diagnostic Tester.
The qualified personal (Audi high voltage technician) restarts the vehicle.
The Audi high voltage technician should put a sign on the vehicle to identify it as a high voltage vehicle.

NOTE:

Restart the high voltage system:

Connect the vehicle diagnostic tester.

Select the Guided Fault Finding mode.

Using the GO TO button, select the following menu commands

Function/Component Selection

Body

Electrical Equipment

OBD-capable systems

8C - Battery Regulation Control Module -J840

8C - Battery Regulation Control Module, functions

51 - High voltage restart

-- Turn on the ignition.

-- Check the DTC memory for the Climatronic Control Module -J255- display and control head and the A/C Compressor Control Module -J842- and, if necessary, erase the displayed faults using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

-- Operate the A/C system after filling the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

NOTE:

Observe the information regarding operating the A/C system after filling. Refer to A/C SYSTEM, OPERATING AFTER CHARGING , (Refrigerant R134a, Servicing; A/C System, General Information). After charging the A/C system before activating the A/C system.