Ribbed Belt, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
-- Route the ribbed belt over the ribbed belt pulley in the sequence specified.
- Generator
- Idler Roller
- Coolant Pump
- Power Steering Pump
- A/C Compressor
- Ribbed belt tensioner
- Vibration Damper with Ribbed Belt Pulley
NOTE:
When installing the ribbed belt, make sure it is seated correctly on the pulleys.
-- Start the engine and check the belt routing.
-- Install the noise insulation, refer to FRONT NOISE INSULATION .