LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q5 2.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 541 (3.0L - Crankshaft & Cylinder Block - Engine Code(S): CCBA, CGXC & CTUB (Sedan)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Sensor Wheel, Removing And Installing >> Removing

Sensor Wheel, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

CAUTION:

There is a risk of destroying the sensor wheel by magnetic force.

  • Do not place the sensor wheel near magnets (for example inspection lamp base, or speakers).
  • If the drive plate/flywheel or the sensor wheel removes on its own or is replaced, before installing the sensor wheel function must be checked. Refer to SENSOR WHEEL, CHECKING .

-- Remove the sensor wheel -arrow-.

Fig 1: Identifying Sensor Wheel
GWWA28-10118Courtesy of AUDI OF AMERICA, LLC