Overview - Drive Plate
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For assembly work, secure the engine on the Engine and Gearbox Bracket VAS6095A. Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .
- Drive Plate
- With the bearing flange
- Check the running surfaces on the bearing flange and the clutch module holes for cracks and wear grooves.
- Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Bolt
- 60 Nm + 90° turn
- Replace
- Needle Bearing
- Installed position: the closed side faces the engine
- Removing and installing. Refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .
- Sensor Wheel
- For Engine Speed Sensor -G28-
- Crankshaft
- Alignment Pin
- Crankshaft Shaft Seal, Transmission Side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .