Tire Pressure Monitoring Control Module 2 -J502-, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Installation is the reverse of removal, with special attention to the following:
-- If the center console was pulled out of the instrument panel when pulling the carpet back, insert the center console with the pins -1- in the instrument panel -2-.
-- Tighten the nuts -1- to 2 Nm.
-- The system must be coded again if the Tire Pressure Monitoring Control Module -J502- is replaced. Refer to TIRE PRESSURE MONITORING SYSTEM, SYSTEM DESCRIPTION and Vehicle Diagnostic Tester.