LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q5 2.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 1309 (Wheels, Tires, Wheel Alignment (Suspension, Wheels, Steering) (TPMS - Lane Assist) (Cabriolet)) >> 44 Wheels, Tires, Wheel Alignment >> Lane Assist >> Directional Stabilization Assistance Control Module -J759- And Lens Screen, Removing And Installing >> Installing

Directional Stabilization Assistance Control Module -J759- And Lens Screen, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Installation is the reverse of removal, with special attention to the following: 

NOTE:

The camera visual area on the inside of the window must not be covered with condensation or dirty. If it is, clean the visual window by hand using a Cleaning Solution.

If the Directional Stabilization Assistance Control Module -J759- is replaced, the Camera -- and the Directional Stabilization Assistance Control Module -J759- must be calibrated. Refer to LANE ASSIST, CALIBRATING .

scientia non olet · About LEMON Manuals