Adaptive Cruise Control Sensor -G550-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Installation is the reverse of removal, with special attention to the following:

NOTE:

The stud bolts in the bracket are preset. If necessary, correct the setting.

-- Place the Adaptive Cruise Control Sensor -G550- on a soft, clean cloth.

Measure Dimension a of All Studs.

Fig 1: Identifying Dimension -A- To All Studs

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- must be 43 mm.

-- Insert bracket and tighten bolts.

-- Inset the Adaptive Cruise Control Sensor -G550- and carefully push the nuts onto the threaded pins in the sensor.

RS Models:

-- Install the air guide to the coolant auxiliary cooler. Refer to appropriate service information. .

-- Install the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

All Models:

-- Install the air intake grille. Refer to FRONT BUMPER .

-- Calibrate the adaptive cruise control. Refer to ACC, CALIBRATING, CALIBRATION PROCEDURE WITH ACC Setting Device .