LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q5 2.0T >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L - Engine Assembly - Engine Code(S): CAEB, CHJA, CPMA & CPMB >> 10 Engine Assembly >> SUBFRAME Mount >> Overview - SUBFRAME Mount >> Overview - SUBFRAME, Engine Mount

Overview - SUBFRAME, Engine Mount

Fig 1: Identifying Subframe Mount
GWWA10-11044Courtesy of AUDI OF AMERICA, LLC
  1. Not installed
  2. Bolt
    • 20 Nm
  3. Retaining Plate
    • For the engine mount
    • If the engine mount is faulty, replace the retaining plate
    • Check the retaining plate on the opposite side; replace if necessary
  4. Bracket
    • For the hydraulic line
  5. Nut
    • 9 Nm
  6. Bolt
    • 40 Nm
  7. Engine Support
  8. Bolt
    • 10 Nm
  9. Heat Shield
  10. Bolt
    • 90 Nm +90° turn
    • Replacing
  11. Engine Mount
    • With the Left Electrohydraulic Engine Mount Solenoid Valve -N144-
    • Depending on version along with Right Electrohydraulic Engine Mount Solenoid Valve -N145-
    • Removing and installing, refer to ENGINE MOUNT, REMOVING AND INSTALLING .
    • Replace in pairs only
  12. Subframe
  13. Bolt
    • 55 Nm
scientia non olet · About LEMON Manuals