Gas-Filled Strut, Removing And Installing

NOTE:

After completely removing gas-filled strut, ensure correct position when installing.

Noise insulation component must be installed on the body side.

Fig 1: Identifying Retaining Spring, Screw Driver, And Gas-Filled Strut

Courtesy of AUDI OF AMERICA, LLC

-- Remove retaining spring -2- with small screwdriver -1- and disengage gas-filled strut -3-, that can finally be removed from ball stud.

Installing

Install in reverse order of removal. Note the following:

-- To install, press gas-filled strut onto ball head pins so that it engages in position.

-- Ball head pin tightening specification. Refer to -item 3- Ball Stud (See Figure).