LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q5 2.0T >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Front >> 50 Body Front >> Bulkhead >> Plenum Chamber Cover, Removing And Installing

Plenum Chamber Cover, Removing And Installing

NOTE:

Note different versions.

Fig 1: Identifying Plenum Chamber Cover
GWWA50-10309Courtesy of AUDI OF AMERICA, LLC
  1. Cowl Panel Trim
    • The wiper arm is removed.
    • The left, center and right auxiliary covers are removed.
    • Remove the clamps -3-.
      NOTE:

      For easier removal/installation, spray windshield edge strip with soapy solution.

    • Pull the cowl panel straight off the frame starting from the window edge.
      CAUTION:

      Risk of window breaking during installation

      When installing, do not hit the cowl trim.

      Carefully press cowl trim in sideways, beginning in the frame.

  2. Plenum Chamber Cover
    • Remove the front clip first when removing.
    • Lift the front cover and remove it from the plenum chamber cover.
  3. Seal
    • Remove from the body flange toward the rear starting on the side.
  4. Plenum Chamber Bulkhead
  5. Windshield
  6. Frame
scientia non olet · About LEMON Manuals