Outer Rear Three-Point Seat Belt, Removing And Installing: Removing
-- Remove the rear outer belt anchor. Refer to REAR OUTER BELT END FITTING, REMOVING AND INSTALLING .
-- Remove the luggage compartment side trim. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the noise insulation for the automatic belt retractor.
Versions with rear seat belt tensioner igniter:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Follow all regulations when disposing of pyrotechnic components. Refer to AIRBAG, BELT TENSIONER AND BATTERY CUT-OUT UNITS, STORING, TRANSPORTING AND DISPOSING .
-- Turn on the ignition.
-- Disconnect the battery ground cable with the ignition turned on. Refer to GROUND CABLE WITH BATTERY MONITORING CONTROL MODULE -J367-, REMOVING AND INSTALLING .
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Disconnect the connector.
-- To do this, release the connector lock -3- using a small screwdriver -1- and remove the electrical connector -2-.
Continuation for all vehicles:
-- Loosen the bolt -1-.
-- Disengage and remove the automatic belt retractor -2- -arrow-.