Lower Seat Frame Cover And Cushion, Assembly Overview

NOTE:

In the illustration is 2/3 left rear seat is shown.

Fig 1: Identifying Bench Cover And Cushion

Courtesy of AUDI OF AMERICA, LLC

Cushion
- Cover with upholstery, removing and installing. Refer to SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING
- Cover, Separating from Cushion and Connecting. Refer to SEAT PAN COVER AND CUSHION, SEPARATING
Wire
- In foam in upholstery
- For securing cover to upholstery
Cushion clip
- For securing cover to upholstery
- Always replace if removed
- Install in same location as before removal
Contour Strip
- Sewn into cover
- For securing cover to upholstery
Cover
- Cover with upholstery, removing and installing. Refer to SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING
- Cover, Separating from Cushion and Connecting. Refer to SEAT PAN COVER AND CUSHION, SEPARATING
Molding
- Sewn into cover
- For securing cover to upholstery
Cushion Clip
- For securing cover to outer cushion
- Always replace if removed
- Install in same location as before removal
  WARNING:
  Ends of wire clips must face in direction of upholstery after installing and must be bent correctly. Otherwise, there is a risk of injury.
Wire
- In foam in upholstery
- For securing cover to upholstery