Camshaft, Measuring Axial Clearance

Special tools and workshop equipment required 

• Dial Gauge HolderVW387
• Dial Gauge - 0-10mmVAS6079

Procedure 

Fig 1: Securing Dial Gauge Holder VW 387 To Dial Gauge VAS 6080 On Cylinder Head

Courtesy of AUDI OF AMERICA, LLC

-- Remove the camshafts, refer to CAMSHAFT, REMOVING AND INSTALLING .

-- Mark the assignment of the roller rocker lever for installation later.

-- Remove the roller rocker lever and place it on a clean surface.

-- Reinstall the camshafts and the guide frame, refer to Figure and tighten the old bolts to 8 Nm.

-- Secure the Dial Gauge HolderVW387 with the Dial Gauge - 0-10mmVAS6079 on the cylinder head ash shown in the illustration.

-- Press the camshaft against the dial gauge by hand.

-- Set dial gauge to "0".

-- Press the camshaft off the dial gauge and read the value:

• Axial clearance: 0.100 to 0.191 mm.