LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> A7 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.0L - Cylinder Head & VALVETRAIN - Engine Code(S): CGXB & CTUA >> 15 Cylinder Head, VALVETRAIN >> Cylinder Head >> Cylinder Head Cover, Removing And Installing >> Left Cylinder Head Cover, Removing And Installing >> Installing

Left Cylinder Head Cover, Removing And Installing: Installing

Install in reverse order of removal. Note the following:

NOTE:

Replace the cylinder head seal if it is damaged.

Replace the cylinder head cover bolts when replacing the damaged seal.

Replace the O-ring.

-- Clean any oil or grease off the sealing surfaces.

-- Tighten the left cylinder head cover bolts, refer to Figure.

-- Install the ignition coils, refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals