Battery -A- OVERVIEW

Observe notes on contact corrosion. Refer to CONTACT CORROSION .

Fig 1: Identifying Battery Overview

Courtesy of AUDI OF AMERICA, LLC

1. Retaining Bracket
2. Screw
   • 18 Nm
3. Battery
   • Disconnecting and connecting, refer to Battery -A-, DISCONNECTING AND CONNECTING .
   • Removal and installation, refer to Battery -A- 
4. Screw
5. Nut
   • 5 Nm
6. Main Fuse Panel
   • Disconnecting and connecting, refer to Battery -A- 
   • Overview, refer to PLENUM CHAMBER E-BOX, WIRE JUNCTION, FUSE HOLDER AND BATTERY OVERVIEW
7. Negative Terminal Cover
8. Positive Terminal Cover
9. Retainer
   • For the vehicle tool kit cover
10. Screw
    • 18 Nm
    • Quantity: 4
11. Electrical Wire
    • For the battery monitoring control module -J367-
    • Follow the sequence when connecting the ground cable, refer to Battery -A-, DISCONNECTING AND CONNECTING 
12. Ground Wire With Battery Monitoring Control Module -J367-
    • Disconnecting and connecting, refer to Battery -A-, DISCONNECTING AND CONNECTING 
    • Removal and installation, refer to GROUND CABLE WITH Battery Monitoring Control Module -J367- 
13. Nut
    • Tightening specification, refer to appropriate SYSTEM WIRING DIAGRAMS information.
14. Screw
15. Nut
    • 5 Nm
16. Central Venting System Hose
17. Grommet
    • For the hose for the central venting system