Part III

Part I, refer to OVERVIEW - TURBOCHARGER - Part I .

Part II, refer to OVERVIEW - TURBOCHARGER - Part II .

Fig 1: Identifying Turbocharger Overview Part III

Courtesy of AUDI OF AMERICA, LLC

1. Seal
   • Replacing
2. Nut
   • Replacing
   • Tightening sequence, refer to Fig 2
   • Coat the exhaust manifold stud bolts with hot bolt paste.
3. Bolt
   • 35 Nm
4. Seal
   • Replacing
5. Coolant Supply Line
6. Bolt
   • 9 Nm
7. Turbocharger
   • Can only be replaced with exhaust manifold and vacuum diaphragm.
   • Removing and installing, refer to TURBOCHARGER, REMOVING AND INSTALLING .
8. Bolt
   • 30 Nm
9. Bracket
10. Support
11. Bolt
    • 30 Nm
12. Bolt
    • 30 Nm
    • Coat the bolt with hot bolt paste.
13. Nut
    • 30 Nm
    • Do not open when removing turbocharger
    • Replacing
    • Coat the exhaust manifold stud bolts with hot bolt paste.
14. Clamping Strip

Fig 2: Identifying Turbocharger Nut Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nuts -1 through 5- in four steps as follows:

-- Tighten the nuts to 5 Nm.

-- Tighten the nuts to 12 Nm.

-- Tighten the nuts to 16 Nm.

-- Tighten the nuts to 25 Nm.

Additional Tightening Specifications