LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> A6 2.0T >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels (Hood, Lids) >> 55 Hood, Lids >> Hood >> Hood Gas-Filled Strut, Removing And Installing >> Notes

Hood Gas-Filled Strut, Removing And Installing: Notes

Fig 1: Removing/Installing Hood Gas-Filled Strut
GWWA55-10760Courtesy of AUDI OF AMERICA, LLC
  1. Gas-Filled Strut
    • Lift the locking spring slightly and pull the gas-filled strut off the ball stud.
      NOTE:

      Ensure correct positioning during installation: the gas-filled strut tube must be attached on the lid side.

  2. Hood
  3. Suspension Strut Dome
  4. Ball Stud
    • 21 Nm
scientia non olet · About LEMON Manuals